Introduction
This Gravity: liquid flow sensor is designed based on the electromagnetic principle. It adopts an O-ring rubber seal and uses silicone sealant at the outlet end to strength water-resistance. With high anti-interference and anti-impact, the sensor offers reliable performance and long service life. Also, it is designed with G1/4 thread connectors for easy installation.
The sensor can be used with microcontrollers like Arduino UNO to measure the flow of liquids with high concentration and low viscosity like water, diesel, engine oil, milk, paint, detergent, honey, etc. (no impurity in liquid)
Features
Gravity connector, easy to wire
Wide voltage of 3.5-24V
Supports measuring liquid with high concentration and low-viscosity
RoHS compliant Specification
Operating Voltage: DC3.5-24V
Operating Current: 10mADC5V
Output: NPN Pulse signal
Pipe Diameter: G1/4
Thread Outer Diameter: 13mm
Thread Length: 10mm
Water Pressure Resistance: 1.0MPA
Insulation Resistance: 100M
Error: 1%(0.3-5L/min)
Output Pulse High Level: DC4.7V(Input voltage DC5V)
Output Pulse Low Level: DC0.5V(Input voltage DC5V)
Output Pulse Duty Ratio: 50%10%
Flow-Pulse Correlation: 1L=540 pulses
Operating Temperature Range: -10~70C
Operating Humidity Range: 35%~90%RH(No condensing)
Storage Temperature: -25~+80C
Storage Humidity: 25%~95%RH
Dimension: 80*47*30mm/3.15*1.85*1.18
Shipping List
Gravity: Liquid Flow Sensor (G1/4) x1
Documents
Product wiki
Applications
Measure the flow of liquids with high concentration and low viscosity