W5500-EVB-Pico is a microcontroller evaluation board based on the Raspberry Pi RP2040 and fully hardwired TCP/IP controller W5500 – and basically works the same as Raspberry Pi Pico board but with additional Ethernet via W5500.
W5500-EVB-Pico pinout is directly connected to the GPIO of RP2040. It has the same pinout as the Raspberry Pi Pico board. However, GPIO16, GPIO17, GPIO18, GPIO19, GPIO20, GPIO21 are connected to W5500 inside the board. These pins enable SPI communication with W5500 to use Ethernet function. If you are using the Ethernet function, these pins cannot be used for any other purpose.
Features:
- RP2040 microcontroller with 2MByte Flash
- Dual-core cortex M0+ at up to 133MHz
- 264kByte multi-bank high performance SRAM
- External Quad-SPI Flash with eXecute In Place (XIP)
- High performance full-crossbar bus fabric
- 30 multi-function General Purpose IO (4 can be used for ADC)
- 1.8-3.3V IO Voltage (NOTE. Pico IO voltage is fixed at 3.3V)
12-bit 500ksps Analogue to Digital Converter (ADC)
Various digital peripherals
2 × UART, 2 × I2C, 2 × SPI, 16 × PWM channels
1 × Timer with 4 alarms, 1 × Real Time Counter
2 × Programmable IO (PIO) blocks, 8 state machines total
Flexible, user-programmable high-speed IO
Can emulate interfaces such as SD Card and VGA
Includes W5500
Supports Hardwired Internet Protocols: TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
Supports 8 Independent Hardware SOCKETs simultaneously
Internal 32 Kbytes Memory for TX/ RX Buffers
Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3)
Micro-USB B port for power and data (and for reprogramming the Flash)
40 pin 21×51 ‘DIP’ style 1mm thick PCB with 0.1″ through-hole pins also with edge castellations
3-pin ARM Serial Wire Debug (SWD) port
10 / 100 Ethernet PHY embedded
Supports Auto Negotiation
Full / Half Duplex
10 / 100 Based
Built-in RJ45
Built-in LDO
Documents:
- W5500 Datasheet
- RP2040 Datasheet
- Schematic
- Driver
- GitHub
Emballagestørrelse: 8,3 cm * 2,9 cm * 2,9 cm
Vægt: 1,769 gram