Introduction
The DFRobot DF9GMS is a 360 degree micro servo. It uses a plastic gear drive and is light and compact. It can be used for various applications and DIY products, such as toy cars, boats, windmills etc.
A 360 degree servos operation is more similar to a DC motor than a standard servo as only rotation direction and speed can be controlled. There is also no hardware stop inside so that the shaft can rotate freely. Compared to an ordinary DC motor, a 360-degree servo motor does not require additional motor drivers and is plug and play, compact and convenient. Arduino control methods are also the same. When the servo is operating on the 4.8 ~ 6V power supply, the torque can reach 1.2 ~ 1.6Kg x cm
Specification
Operating Voltage: 3.5 – 6.0V
Supply Voltage: 4.8V ~ 6.0V
Dead Zone Width: 5usec
Working Speed: 0.12sec/60 (4.8V no load)
Stall Torque: 1.2kg/cm (4.8V), 1.6kg/cm (6.0V)
Neutral Location: 1500us
Interface Description:
Brown: GND
Red: VCC
Orange: S
Cable Length: 250mm
Operating Temperature: -30C to + 60C
Dimensions: 22.6 x 12.2 x 30 mm /0.89×0.48×1.18
Weight: 91g
Shipping List
DFRobot DF9GMS 360 Degree Micro Servo (1.6Kg)x1
Accessoriesx1